Filter
Top Products
Quantum Scale System
Introduction to This Manual 1 - 4
How to Use This
Manual
Refer to the following sections for information about using
the Quantum Scale System.
♦ Chapter Two: General Information provides you basic
information about the Quantum’s features including:
* Standard Features
* Communications Connections
* Reset Button
* Control Panel Overview
* Screen Highlights
* Mechanical Procedures
* HELP Key Functions
♦ Chapter Three: Start Up Procedures provides you an
overview of the Power-up Sequence and how to set,
check or change Date/Time.
♦ Chapter Four: Understanding and Using the Start a Run
Screen provides you an overview of the screen, verifying
zero weight, identifying, understanding and selecting
Weigh and Totals Types, and entering Operator ID’s.
♦ Chapter Five: Entering PLU Information describes how to
enter PLU data (i.e., through Flashkeys, typing the PLU
number or pressing the HELP Key to use the On Screen
Library).
♦ Chapter Six: Weigh Types details how to perform a
transaction within each mode of operation (i.e., Wait on
a Customer, PrePackaged Products, etc.)
♦ Chapter Seven: Temporary Override of Product Information
gives you the details of how to temporarily change
product information for a specified Weigh Type.
♦ Chapter Eight: Cleaning Instructions gives you
procedures for cleaning the exterior of the scale and the
printhead.
♦ Chapter Nine: Troubleshooting provides you operating
tips to assist you with unexpected scale problems.
♦ The Appendix provides you additional information on
the following:
* Creating Macros (Using the Save/Recall Key)
* Percentage Tare (Proportional Tare)
* Label Types
* Graphics
* Glossary of Commonly Used Terms
♦ The Index provides you a listing of the topics in this
manual and their corresponding page numbers.