Filter
Top Products
Quantum Scale System
Start-Up Procedures 3 - 4
☛ Note
There may be a slight delay during Scale Warm-up
(depending on room temperature) until the Zero weight
appears on the screen. If during Power-up, the Scale Warm-
up Box does not disappear from the display screen, contact
your local Hobart office for service.
Setting Date & Time
on Initial Setup
QUICK STEPS
From the Start a Run Screen:
1. PRESS [F1]
2. TYPE the Current Date
3. PRESS [ENTER] or [▼]
4. TYPE the Current Time.
5. PRESS [F1] - If Needed
6. PRESS [ESC]
To set the Date and Time the first time you setup the scale:
1. From the Start a Run Screen, PRESS [F1].
2. With the cursor in the Date field, TYPE the current Date.
Enter the Date as a six-digit number (MM/DD/YY).
3. PRESS [ENTER] or [DOWN ARROW (▼)] to move the
cursor to the Time field.
4. With the cursor in the Time field, TYPE the current
Time. Enter the Time as a four-digit number (HH:MM).
5. If you need to change AM or PM, PRESS [F1] to select
the correct time of day.
6. When the Date and Time is correct, PRESS [ESC] to save
the changes and return to the Start a Run Screen.
☛ Note
If designated during Scale Setup, any operator may be
permitted to change Date/Time. Refer to Scale Setup in the
Supervisor Manual. The Supervisor must change
Date/Time if not designated during Scale Setup.