Filter
Top Products
Reference Manual
00809-0200-4101, Rev AA
July 2008
C-9
Rosemount 2051
self_test 59 Instructs resource block to perform self-test. Tests are device specific.
distributor 42 Reserved for use as distributor ID. No Foundation enumerations defined at this time.
REM_SEAL_FILL 73 Type of fill fluid used in the remote seals.
2 = Silicone
3 = Syltherm 800
4 = Inert (Halocarbon)
5 = Glycerin and Water
6 = Propylene Glycol and Water
7 = Neobee M–20
251 = None
252 = "Unknown"
253 = "Special"
REM_SEAL_ISO_MAT 70 Type of material of the remote seal isolators. See remote seal number codes.
2 = 316L Stainless Steel
3 = Hastelloy C–276
5 = Tantalum
9 = Co–Cr–Ni
251 = None
252 = "Unknown"
253 = "Special"
REM_SEAL_NUM 71 Number of remote seals.
1 = One seal
2 = Two seals
251 = None
252 = "Unknown"
253 = "Special"
REM_SEAL_TYPE 66 Type of remote seals.
0 = Undefined
1 = Reserved
2 = CTW
3 = EFW (Expanded Flange Seal)
4 = PFW (Pancake)
5 = RFW (Flanged Remote)
6 = RTW (Threaded Remote)
7 = SCW
8 = SSW
9 = High Temperature
10 = FFW (Flanged Flush Surface)
11 = UCW
12 = TSW
251 = None
252 = "Unknown"
253 = "Special"
RESTART 16 Allows a manual restart to be initiated. Several degrees of restart are possible. They are
the following:
1 Run – nominal state when not restarting
2 Restart resource – not used
3 Restart with defaults – set parameters to default values. See
START_WITH_DEFAULTS below for which parameters are set.
4 Restart processor – does a warm start of CPU.
RS_STATE 07 State of the function block application state machine.
save_config_blocks 62 Number of EEPROM blocks that have been modified since last burn. This value will count
down to zero when the configuration is saved.
save_config_now 61 Controls saving of configuration.
security_IO 65 Status of security jumper/switch.
SHED_RCAS 26 Time duration at which to give up on computer writes to function block RCas locations.
Shed from RCas shall never happen when SHED_ROUT = 0
SHED_ROUT 27 Time duration at which to give up on computer writes to function block ROut locations.
Shed from ROut shall never happen when SHED_ROUT = 0
Parameter
Index
Number
Description