Filter
Top Products
ViewStation EX, ViewStation FX, and VS4000 API Guide
© Polycom, Inc. 2003 193
V.35/RS-449/RS-530/RS-366 Commands
The following commands are specific to the V.35/RS-449/RS-530/
RS-366 network interface.
cts <normal|inverted|get>
Description
This command lets you configure the cts serial interface control
signal (clear to send). The default setting for this signal is normal.
normal Sets the signal to normal (high voltage is logic 1).
inverted Sets the signal to inverted (low voltage is logic 1).
get Displays the current setting (normal or inverted).
Example
cts normal
User Interface Screen Location
System Info>Admin Setup>Video Network>Advanced V.35: CTS
This screen is only accessible if you have a V.35/RS-449/RS-530/
RS-366 network interface connected to your system.
dcd <normal|inverted|get>
Description
This command lets you configure the dcd serial interface control
signal (data carrier detect). The default setting for this signal is
normal.
normal Sets the signal to normal (high voltage is logic 1).
cts
dcd