Mitsubishi Electronics MR-MC240 Sleep Apnea Machine User Manual


 
App. - 54
APPENDIX
App. 5.15.3 Servo parameter change number
When parameter settings within the servo amplifier are changed using the auto tuning function or parameter
changes using MR Configurator2 (set up software), the bit corresponding to the servo parameter number that
was changed is turned on to notify concerning which parameter number was changed (in units of 16). To
identify the changed parameter, check the servo parameter change number (monitor No.0580 to 058F)
corresponding to the bit which is turned on. To identify the changed parameter, check the servo parameter
change number (monitor No.0590 to 05B7) corresponding to the bit which is turned on. Refer to Section 7.2 for
more information.
(1) Servo parameter change number (SSCNET
)
Address Content Address Content
3800
Servo parameter
change number 01
Axis 1
3818
Servo parameter
change number 01 Axis 13
3801 3919
3802 Servo parameter
change number 01
Axis 2
381A
Servo parameter
change number 01
Axis 14
3803 381B
3804 Servo parameter
change number 01
Axis 3
: :
3805
3806 Servo parameter
change number 01
Axis 4
383E Servo parameter
change number 01 Axis 32
3807 383F
3808 Servo parameter
change number 01
Axis 5
3840
Reserved
3809 3841
380A Servo parameter
change number 01
Axis 6
:
380B
380C Servo parameter
change number 01
Axis 7
385E
380D 385F
380E Servo parameter
change number 01
Axis 8
380F
3810 Servo parameter
change number 01
Axis 9
3811
3812 Servo parameter
change number 01
Axis 10
3813
3814
Servo parameter
change number 01
Axis 11
3815
3816 Servo parameter
change number 01
Axis 12
3817
(2) Details on servo amplifier change number on axis n (SSCNET
)
Address Name Abbreviation Remarks
3800
Servo parameter
change number 01
PSN01
bit0: Parameter No.0100 to 010F
to
bit15: Parameter No.01F0 to 01FF
3801
Note. The address in the table is the address for the axis 1. For the axis 2 and above, increase in units of 2h for each axis.