Filter
Top Products
Upgrading CMS to the High Availability Option
CentreVu
CMS R3V8 High Availability
Connectivity, Upgrade and Administration
Verifying the Tape Drive on an Enterprise 3000 Server 3-6
Verifying the Tape Drive on an Enterprise 3000 Server 3
This procedure is required only for Ha systems which use an E3000 -
E3500 platform combination for the primary and secondary servers.
WARNING!
After the original tape drive on an Enterprise 3000 is replaced with
an Exabyte Mammoth 20-40 Gbyte 8 mm drive, the customer must
discard any old tapes which were formerly used with the old drive.
Reuse of old tapes on the replacement drive will result in damage to
the tape device.
For HA systems in which a new Enterprise 3500 platform is installed in
combination with an Enterprise 3000 that is already in service, the tape
drive on the 3000 must be replaced with an Exabyte Mammoth 20-40
Gbyte 8mm drive (EXB-8900).
The tape drive replacement, which is performed by a
Sun
technician,
must be completed before the HA upgrade process starts.
Tape Verification
Procedure
3
If a tape device change-out was required, perform the following steps to
confirm that the old tape drive was replaced:
Insert an 8mm 170m AME tape cartridge in the tape drive on the
Enterprise 3000 server and enter:
mt -f /dev/rmt/0 status
If the drive has been replaced, the system responds:
Mammoth EXB-8900 8mm Helical Scan tape drive:
sense key(0x0)= No Additional Sense
residual= 0 retries= 0
file no= 0 block no= 0