Filter
Top Products
Connecting HA Servers to the Switch
CentreVu
CMS R3V8 High Availability
Connectivity, Upgrade and Administration
Connecting to the Definity Switch 2-8
Cabling Procedure 2
This procedure describes the step required to make the connection
between a dual ACD link and the HA server. For more information, refer
to the “Cabling Diagram - LAN via 10Base-T Hub” on Page 2-8
.
1. Do one of the following:
• Attach an adapter (259A, 258B, or 356A) to the backplane
connector of the TN799 C-LAN circuit pack, then attach one
end of an RJ45 Category 5 modular cord to the adapter. Use
jack #1 on the 258B or 356A adapters.
• Connect the ethernet port of a TN799 C-LAN circuit pack to
a Category 5 connecting block using Category 5 cross-connect
wiring, then attach one end of an RJ45 Category 5 modular
cord to the connecting block.
2. Connect the other end of the modular cord to a port on
the 10Base-T hub.
3. Connect another RJ45 Category 5 modular cord to a different port
on the 10Base-T hub.
4. Connect the other end of the modular cord to an ethernet port on the
CMS computer.
5. Connect and apply power to the 10Base-T hub.
Cabling Diagram - LAN
via 10Base-T Hub 2