Open as PDF
2. BRIDGE PANEL
2.2 How to Turn the Bridge Panel On/Off
Press the BRILL key to turn on the Bridge Panel. The start-up screen appears.
The program number is shown and the system checks the ROM and RAM. If the ROM
and RAM are normal, OK appears for their check results. If NG (NoGood) appears for
any check result, reset the power to try to restore normal operation. If NG still appears,
contact your dealer.
Press any key at the start-up screen to go to the standby display (see section 2.4).
You can also go to the standby display if you wait 10 seconds after the completion of
the start-up check.
To turn off the Bridge Panel, press the BRILL key until the power goes off (approx. 10
BRIDGE ALARM SYSTEM
FURUNO䇭ELECTRIC CO., LTD.
BRIDGE PANEL BR-1010
PROGRAM No. 2450041-01.xx