Filter
Top Products
25
Note If you use Cisco Unified CallManager as a TFTP server, Service Monitor cannot copy
configuration files to Cisco Unified CallManager due to security settings on the latter. You will
need to manually upload the configuration file as described in Step 3e. After uploading the
configuration file, reset the TFTP server on Cisco Unified CallManager. For more information,
see Cisco Unified CallManager documentation.
Step 4 Wait a few minutes and verify that sensors have registered to Service Monitor. If they have
not, reset the sensors by disconnecting them from power and connecting them again.
Warning
Before disconnecting a sensor, read the regulatory compliance and safety information in
Quick Start Guide for Cisco 1040 Sensor.
Sample Sensor Configuration Files
Service Monitor creates these files when you edit the configuration through the user interface and when
a sensor uses the default configuration file to register. These samples are provided to enable you to
confirm that the contents of a sensor configuration file are correct.
Note Always use the Service Monitor user interface to edit sensor configuration files to ensure that
Service Monitor functions properly. Do not edit sensor configuration files on the TFTP server.
Default Configuration File—QOVDefault.CNF
In the default configuration file, the ID, A000, is a placeholder; an IP address or alternatively a DNS
name is provided for the Receiver. The last updated data and time represent the last time that the
default configuration was updated from the Service Monitor user interface.
Receiver=10.92.99.22;;
ID=A000
Image=SvcMonAA2_34.img
LastUpdated=11_16_2006-6_59_46.78
CDPGlobalRunState=true
SyslogPort=UDP:5666
SkinnyPort=TCP:2000