Filter
Top Products
Operation
25
• Wipe the control solution vial tip with a
lint-free cloth or tissue before replacing
the cap.
4
Check the confirmation dot on the back
of the test strip to verify it has turned
completely blue, indicating an adequate
amount of control solution was applied.
If white patches or streaks are visible, you
have not applied enough control solution.
Repeat the application with a new test strip.
5
Firmly insert the test strip all the way
into the test strip holder until it stops
(the confirmation dot should be facing
down).
SSHosp.book Page 25 Thursday, November 14, 2002 3:44 PM