Filter
Top Products
Introduction
13
• Replace the test strip bottle cap
immediately after removing a test strip
and close the cap tightly.
• Do not use test strips that are bent, torn,
cut, or damaged in any way.
• Use each test strip immediately after
removing it from the bottle.
• Do not transfer test strips to a new bottle
or any other container.
• Compare the color of the test strip
confirmation dot to the “Unused” color dot
shown on the Color Chart on the test strip
bottle label. If the color of the test strip
confirmation dot is darker than that shown
on the Color Chart, do not use the test strip.
The result may be inaccurate.
• You have up to 2 minutes to insert the
test strip into the meter after applying
blood or control solution. If you insert the
test strip after 2 minutes, you may get an
inaccurate result or an error message.
SSHosp.book Page 13 Thursday, November 14, 2002 3:44 PM