Filter
Top Products
GETTING YOUR InDuo
TM
SYSTEM READY FOR USE 13
Match the code numbers
The calibration code is stored in the meter memory
until you change it. The current code number will
appear on the display for 3 seconds.
•
Compare the code number on the meter display with
the code number on the OneTouch
®
Ultra test strip vial
.
• If the 2 code numbers match, you may begin
testing.
• If the code numbers do not match, follow the next
procedure to recode the InDuo
TM
meter.
Code the InDuo
TM
meter
• Press Ñ to select the correct code.
• Each time you press and release Ñ, the number
on the display will increase by one.
• To scroll faster, hold Ñ down.
• After you have selected the correct code number, it
will flash for 3 seconds and then appear solid for 3
seconds.
• The apply symbol R will appear with the units of
measurement (Á or fi), indicating that
the InDuo
TM
meter is ready for testing.
(Example)
DCO_06084101C_InDuo_OB_US 8/16/04 1:08 PM Page 13