Support User Manuals

Invacare Spree XT Mobility Aid User Manual

Open as PDF

of 76

SECTION 10—TILT

Part No 1118364 67 Spree XT

3. Informtheoccupantofthewheelchairthatthewheelchairisabouttobetiltedand

remindthemtoleanback.

4. Makesuretheoccupantʹshandsand

bodyareclearofallpinchpoints.

5. Standbehindthewheelchairandgrasp

bothbackcanesfirmly.

6. Pulluponthetriggerreleaseleversto

engagethetiltmechanism.

7. Slowly,pushdownonthebackcanes

whilepullinguponthetriggerrelease

leversinacontinuousmotion.

8. Whentheseatreachesthedesired

angle,slowlyletgoofthetrigger

releaselevers.

FIGURE 10.1 Engaging Tilt in Space

Adjusting the Cable Assembly

ƽ WARNING

DO NOT operate the tilt-in-space if the release handles and cables are not properly

adjusted to ensure that the wheelchair holds the tilted position.

NOTE:Forthisprocedure,referto

FIGURE10.2.

1. Loosenthejamnut(counterclockwise)

onthecable.

2. Turnthecableadjusteruntiltherelease

handlesengagethetiltmechanism

properly.

3. Retightenthejamnut(clockwise)on

thecable.

4. Tiltthewheelchairtoanytiltposition.

Makesurethewheelchairholdsthe

position.

NOTE:Ifthewheelchairdoesnotholdthe

position,repeatSTEPS1‐4untilthe

wheelchairisabletoholdthetiltedposition.

FIGURE 10.2 Adjusting the Cable

Assembly

Trigger

Release

Lever

Cable Adjuster

Jam Nut

previous next