Support User Manuals

Invacare Spree XT Mobility Aid User Manual

Open as PDF

of 76

SECTION 5—ARMS

Part No 1118364 43 Spree XT

Installing Locking Cantilever Arms

NOTE:Forthisprocedure,refertoFIGURE5.2.

NOTE:Whenremovingthelocknutsandwashersfromthecantileverarmassembly,leavethetop

hexbolt,covedwashersandspacer(betweenadjustmentplateandcantileverarm)inplace.

1. Slidethepartiallyassembledcantileverarmassemblywithmountinghardware

throughthebackcane.Makesuretheadjustmentplateistowardstheinsideofthe

wheelchair.

NOTE:Thisincludestophexbolt,covedwashersandspacer(betweenadjustmentplateand

cantileverarm).

2. Slidethebottomhexbolt(w/covedwasher)throughtheadjustmentplateandback

cane.

3. Securelytightenthecantileverarmtothewheelchairwithtwolocknutsandwashers.

4. Adjusttheangleofthecantileverarm,ifnecessary.RefertoAdjustingLocking

CantileverArmAngleonpage 44.

Adjusting Locking Cantilever Arm Height

NOTE:Forthisprocedure,refertoFIGURE5.2.

NOTE:Whenremovingthelocknutsandwashersfromthecantileverarmassembly,leavethetop

hexbolt,covedwashersandspacer(betweenadjustmentplateandcantileverarm)inplace.

1. Removethetwolocknutsandwasherssecuringthecantileverarmassemblytothe

backcane.

2. Removethecantileverarmassemblywithhardwarefromthebackcane.

3. PerformSTEPS1‐4inInstallingLockingCantileverArmsonpage 43torepositionthe

armatthedesiredheight.

FIGURE 5.2 Installing Locking Cantilever Arms - Adjusting Locking Cantilever Arm Height

Locknuts

Washers

Back Cane

Adjustment Plate

Coved

Washers

Actuator

Spacer

Top Hex Bolt and

Coved Washer

Bottom Hex Bolt

Cantilever Arm

previous next