Support User Manuals

Invacare Spree XT Mobility Aid User Manual

Open as PDF

of 76

SECTION 5—ARMS

Part No 1118364 45 Spree XT

Using/Installing/Adjusting Non-Locking Cantilever

Arms

ƽ WARNING

DO NOT use lap trays with non-locking cantilever arms.

Using Non-Locking Cantilever Arms

ƽ WARNING

DO NOT use lap trays with non-locking

cantilever arms.

NOTE:Forthisprocedure,referto

FIGURE5.4.

1. Pulltheendofthecantileverarmdown

tolowerthecantileverarm.

2. Pulltheendofthecantileverarmupto

moveitoutoftheway.

FIGURE 5.4 Using Non-Locking Cantilever

Arms

Installing Non-Locking Cantilever Arms

NOTE:Forthisprocedure,refertoFIGURE5.5.

1. Removethelocknutandwasherfrom

thelowerhexboltinstalledonthe

non‐lockingcantileverarm.

2. Slidehexboltofthecantileverarm

assemblyintothedesiredbackcane

mountinghole.

3. Securethecantileverarmtothe

wheelchairwithawasherandlocknut.

4. Adjust

theangleofthecantileverarm,

ifnecessary.RefertoAdjusting

Non‐LockingCantileverArmAngleon

page 46.

FIGURE 5.5 Installing Non-Locking

Cantilever Arms - Adjusting Non-Locking

Cantilever Arm Height

Back Cane

Cantilever Arm

Rear

Coved Washers and

Spacer

Locknut

Washer

Lower Hex Bolt

Cantilever Arm

Back Cane

previous next