Support User Manuals

Invacare Spree XT Mobility Aid User Manual

Open as PDF

of 76

SECTION 5—ARMS

Spree XT 44 Part No 1118364

Adjusting Locking Cantilever Arm Angle

NOTE:Forthisprocedure,refertoFIGURE5.3.

NOTE:Thisadjustmentisrecommendedifthebackanglehasbeenchangedtokeeparmparallel

totheground/floor.

1. Flipthecantileverarmupandoutoftheway.

2. Removethelocknutthatsecuresthelockingpintothearmadjustmentplate.

3. Determinethemountingholeinthearmadjustmentplatethatwillbeusedto

correspondtothebackangle(FIGURE5.3).

4. Securelytightenthelockingpinandwashertotheadjustmentplatewithalocknut.

5. RepeatSTEPS1‐4fortheoppositeside,ifnecessary.

FIGURE 5.3 Adjusting Locking Cantilever Arm Angle

Locking Pin

Adjustment Plate

Locknut

Washer

DETAIL “A” - CORRESPONDING ARM ADJUSTMENT TO BACK ANGLE

Arm

Adjustment

Plate

Back Angle Bracket

86°

Arm

Adjustment

Plate

Back Angle Bracket

90°

Arm

Adjustment

Plate

Back Angle Bracket

94°

Arm Adjustment

Plate

Back Angle Bracket

98°

Arm

Adjustment

Plate

Back Angle Bracket

102°

Arm Adjustment

Plate

Back Angle Bracket

106°

NOTE:Thisadjustmentwillensurethearmisparalleltotheseat.

previous next