Support User Manuals

Invacare Spree XT Mobility Aid User Manual

Open as PDF

of 76

SECTION 4—FRONT RIGGINGS

Part No 1118364 37 Spree XT

Adjusting Adjustable Angle Flip-Up Footplates

ƽ WARNING

When determining the angle of the footplates, make sure the rear of the footplates

DO NOT interfere with the movement of the front casters. Otherwise, injury or

damage may occur.

NOTE:Forthisprocedure,refertoFIGURE4.6.

Depth Adjustment

1. Removethetwoflatscrewsandlocknutsthatsecurefootplatetothehalfclamp.

NOTE:Observetheangleofthefootplateforreinstallation.

2. Movethefootplatetooneoffourmountingpositions.

NOTE:Ifdesireddepthisstillnotobtained,rotatethehalfclamponthefootplatehinge180°.

3. Retightenthetwoflatscrewsandlocknuts.

NOTE:Thesettingforpositioningthefootplateonthehalfclampmayvaryforeachfootplate.

4. RepeatSTEPS1‐3foroppositefootplate,ifdesired.

Angle Adjustment

1. Loosen,butDONOTremovetheadjustmentscrewinthehalfclamp.

2. Positionthefootplatetothenecessaryangletoaccommodatetheuser(Detail“A”).

3. Retightentheadjustmentscrew.Torquetoover90in‐lbs,butnomorethan300in‐lbs.

4. RepeatSTEPS1‐3foroppositefootplate,ifdesired.

5. Screwinoroutuntiltheadjustableangleflip‐upfootplateisperpendiculartothe

footrestassemblyorthedesiredinversion/eversionisobtained.

FIGURE 4.6 Adjusting Adjustable Angle Flip-Up Footplates

Footplate

Hinge

90° Footrest Support

Flat Screws

Footplate

Half Clamp

Adjustment Screw

Locknuts

Footplate

Footrest Support

Detail “A” - Side View of Footplate and Footrest

Support

previous next