Support User Manuals

Invacare Spree XT Mobility Aid User Manual

Open as PDF

of 76

SECTION 7—WHEELS/FORKS

Spree XT 60 Part No 1118364

Permanent Axle

NOTE:Forthisprocedure,refertoFIGURE7.2.

NOTE:Toremoverearwheels,reversethisprocedure.

1. Removethepermanentaxlesfromthepackagedcontainer.

2. Installpermanentaxlethroughtherear

wheelandaxlemountingplate.

3. Securelytightenthewheeltothe

wheelchairframewithlocknut.

NOTE:Only12‐inchrearwheelisshown.

All

otherwheelswillinstall/removeinthesame

manner.

4. RepeatSTEPS2‐3forotherrearwheel

assembly.

5. Adjustthewheellocks.Referto

AdjustingtheQuick‐ReleaseAxle

on

page 60.

FIGURE 7.2 Removing/Installing Rear

Wheels - Permanent Axle

Adjusting the Quick-Release Axle

NOTE:Forthisprocedure,refertoFIGURE7.3.

1. Removerearwheelandquick‐releaseaxlefromthewheelchair.Referto

Removing/InstallingRearWheelsonpage 59.

2. Depressdetentpininthequick‐releaseaxleandslideaxlethroughthewheelhub.

3. Increaseordecreaseendplayinthe

quick‐releaseaxlebyadjustingthe

locknutontheendofthequick‐release

axle.

4. Reinstallrearwheelontothe

wheelchair.Referto

Removing/InstallingRearWheelson

page 59.

5. Releasedetentpinensuringthatthe

lockingpinsarefullyreleased.

6. RepeatSTEPS3‐5untilthe

quick‐releaseaxlelocksproperly.

7. RepeatSTEPS1‐6foroppositeside,if

necessary.

FIGURE 7.3 Adjusting the Quick-Release

Axle

Permanent Axle

Rear

Wheel

Locknut

Axle Mounting

Plate

Wheelchair Frame

Rear Wheel

(Reference)

Locking Pin

Detent Pin

Quick-release

Axle

Axle Mounting

Plate

Locknut

Wheel Hub

(Reference)

previous next