Support User Manuals

Invacare Spree XT Mobility Aid User Manual

Open as PDF

of 76

SECTION 4—FRONT RIGGINGS

Part No 1118364 35 Spree XT

Adjusting Footrest Height

Height Adjustment Ranges

NOTE:Ifusinganytypeofextensionwiththeadjustableflip‐upfootplate.RefertoAdjusting

AdjustableAngleFlip‐UpFootplatesonpage 37.

60°, 70° and 70° Taper

NOTE:Forthisprocedure,refertoFIGURE4.3.

1. Removethefootrestfromthe

wheelchair.Referto

Installing/RemovingSwingaway

Footrestonpage 33.

2. Removethehexscrewandcoved

spacerandslidethefootrestupor

downonitsmountingtubeuntilthe

desiredfootrestheightisachieved.

3. Reassemblethehexscrewandcoved

spacerthroughthefootrestupper

supportandmountingtube(FIGURE

4.3).

FIGURE 4.3 Adjusting Footrest Height -

60°, 70° and 70° Taper

4. Securelytightenthehexscrewand

covedspacer.

5. Installthefootrestassemblyontothewheelchair.RefertoInstalling/Removing

SwingawayFootrestonpage 33.

6. RepeatSTEPS1‐5fortheoppositesideofthewheelchair,ifnecessary.

70° MFX, 90°, 70° LIFT and 90° LIFT Footrests

NOTE:Forthisprocedure,refertoFIGURE4.4.

1. Removeanyaccessoriesthatareattachedtothefootrests.

2. Removethesocketbolt,covedwasherandlocknutthatsecurethefootplatetothe

footrestsupport.

3. Repositionthefootplatetothedesiredheight.

FOOTREST TYPE ADJUSTMENT RANGE

60° 13-17-inches

70° 13-17-inches

90° 5-8-inches

90° 5-11-inches (with 3-inch extension)

Footrest

Mounting

Tube

Coved

Spacer

Hex Screw

Footrest Upper

Support

previous next