Support User Manuals

Invacare Spree XT Mobility Aid User Manual

Open as PDF

of 76

SECTION 4—FRONT RIGGINGS

Spree XT 36 Part No 1118364

4. Reinstallthesocketboltthroughthe

mountingholesofthefootplateand

footrestsupport.

ƽ WARNING

DO NOT overtighten socket bolt and

locknut. Footrest MUST be able to

rotate upward from the horizontal to

the vertical position.

5. Securethefootplatetothefootrest

supportwiththecovedwasherand

locknut.

FIGURE 4.4 Installing/Removing Swingaway

Footrest - 70° MFX, 90°, 70° LIFT and 90°

LIFT Footrests

Installing Adjustable Angle Flip-Up Footplate Hinge

NOTE:Forthisprocedure,refertoFIGURE4.5.

1. Positiontheadjustableangleflip‐upfootplatehingeonthefootrestsupporttubeatthe

desiredheight.

2. PositionthehardwareonthefootrestsupportasshowninFIGURE4.4.

3. Flipthefootplatehingetotheupposition.

NOTE:Thefootplatehingewillfalltothedownposition.

4. Tightenthesocketscrewandlocknut

thatsecurethefootplatehingetothe

footrestsupportuntilthefootplate

hingeremainsintheupposition.

5. Checktheupanddownmotionofthe

footplatehingetomakesuretheuserof

thewheelchaircanoperatethe

footplateseasily.

NOTE:Ifthe

footplateʹsmotionistootight,

loosenthesocketscrewandlocknut

approximately¼‐turn.

NOTE:Ifthefootplateʹsmotionistooloose,

tightenthesocketscrewandlocknut

approximately¼‐turn.

FIGURE 4.5 Installing Adjustable Angle

Flip-Up Footplate Hinge

Height

Adjustment

Holes

Socket Bolt

Locknut

Footrest Support

Footplate

Footrest

Support

Tube

Socket Screw

Locknut

Footplate

Hinge

previous next