Support User Manuals

Invacare Spree XT Mobility Aid User Manual

Open as PDF

of 76

SECTION 4—FRONT RIGGINGS

Part No 1118364 33 Spree XT

SECTION 4—FRONT RIGGINGS

ƽ WARNING

After ANY adjustments, repair or service and BEFORE use, make sure all attaching

hardware is tightened securely - otherwise injury or damage may occur.

Installing/Removing Swingaway Footrest

NOTE:Forthisprocedure,refertoFIGURE4.1.

Installing

1. Turnthefootresttotheside(openfootplateisperpendiculartothewheelchair).

2. Insertthefrontriggingassemblymountingpinintothemountingtubeofthe

wheelchairframe.

3. Rotatethefootresttowardstheinsideofthewheelchairuntilitlocksintoplace.

NOTE:Thefootplatewillbeontheinsideofthewheelchairwhenlockedinplace.

4. RepeatSTEPS1‐3fortheotherfootrestassembly.

5. Ifnecessary,adjustthefootrestheight.RefertoAdjustingFootrestHeightonpage 35.

Removing

1. Pushthefootrestreleaseleverinwardwhilerotatingthefrontriggingoutward.

2. Liftthefootrestassemblyoutofthemountingpinofthewheelchairframe.

3. RepeatSTEPS1‐2foroppositeside,ifnecessary.

FIGURE 4.1 Installing/Removing Swingaway Footrest

Footrest Release Lever

Footrest Assembly

Mounting Tube

Wheelchair Frame

Footplate

NOTE:Only60°Footrest

shownforclarity.Otherswill

attachthesameway.

Mounting Pin

previous next