Support User Manuals

Invacare Spree XT Mobility Aid User Manual

Open as PDF

of 76

SECTION 4—FRONT RIGGINGS

Spree XT 38 Part No 1118364

Installing/Removing Elevating Legrests

NOTE:Forthisprocedure,refertoFIGURE4.7.

Installing

1. Placeelevatinglegrestontheoutsideofthewheelchairandinsertmountingpininto

themountingtube.

2. Rotateelevatinglegresttowardtheinsideofthewheelchairuntilitlocksinplace.

NOTE:Thecalfpadofthe legrestwillbeonthe

insideofthewheelchairwhenlockedinplace.

3. RepeatSTEPS1‐3fortheother

elevatinglegrestassembly.

Removing

1. Pushthelegrestreleasehandleinward

whilerotatingtheelevatinglegrest

outward.

2. Liftthelegrestassemblyoutofthe

mountingtubeofthewheelchairframe.

3. RepeatSTEPS1‐2foroppositeside,if

necessary.

FIGURE 4.7 Replacing Sector Block

Raising/Lowering the Elevating Legrest

NOTE:Forthisprocedure,referto

FIGURE4.8.

1. Performoneofthefollowing:

• Raising:Liftlegrestassemblyupto

desiredheight.

•Lowering:Liftelevatinglegrest

assemblyupwithonehand.While

supportingtheelevatinglegrest

assembly(anduser’sleg),pull

releaseleverupwithotherhand

andlowerlegrestassemblyto

desiredheight.

FIGURE 4.8 Raising/Lowering the Elevating

Legrest

Release Handle

NOTE:Themountingtubewillbe partofthe

seatframeorwheelchairfrontframe

dependingonwheelchairmodel.

Mounting Pin

Mounting

Tube

Elevating

Legrest

Inside of

Wheelchair

Release Lever

Elevating Legrest

Assembly

previous next