Support User Manuals

Invacare Spree XT Mobility Aid User Manual

Open as PDF

of 76

SECTION 5—ARMS

Part No 1118364 47 Spree XT

Arm Pad Replacement for Cantilever Arms

NOTE:Forthisprocedure,refertoFIGURE5.7.

1. Removethemountingscrewsfromthearmrestpad.

2. ReplacewithNEWarmrestpad.

3. Securewithexistinghardware.

FIGURE 5.7 Arm Pad Replacement for Cantilever Arms

Installing/Removing T-Arms

NOTE:Forthisprocedure,refertoFIGURE5.8.

Installing T-Arms

1. PositiontheT‐ArmovertheT‐Arm

socketonthewheelchairframe.

NOTE:Makesurethelockingleveristowards

thefrontofthewheelchair.

2. SlideT‐ArmintoT‐Armsocketuntilthe

lockingleverisintheslotintheT‐Arm

socketandanaudibleʺclickʺisheard.

3. PullUPonT‐ArmtomakesureT‐Arm

islockedinplace.

NOTE:IftheT‐Armdoesnotslideinthe

T‐Armsocketasdesired,adjusttheT‐Arm

socket.RefertoAdjustingT‐ArmSockets

on

page 50.

4. AdjusttheT‐Armfordesiredheight,

widthanddepth,ifnecessary.Referto

AdjustingTheT‐Arms

onpage 48.

5. RepeatSTEPS1‐4foroppositesideof

wheelchair.

FIGURE 5.8 Installing/Removing T-Arms

Full Length Arm Pads

Desk Length

Arm Pads

Armrest Pad

Cantilever

Arm Tube

Mounting

Screws

Cantilever

Arm Tube

Mounting Screws

Arm Pad

Cantilever

Slide Tube

T-Arm

Socket

Locking Lever

(towards the front

of the wheelchair)

T-Arm

Wheelchair

Frame

Slot

previous next