Filter
Top Products
SECTION 10—TILT
Power Tiger™ 70 Part No 1134839
Adjusting the Cable Assembly
ƽ WARNING
DO NOT operate the tilt-in-space if the lock cylinder handles and cables are not
properly adjusted to ensure that the lock cylinders lock in place when engaged.
NOTE: For this procedure, refer to FIGURE 10.2.
1. Loosen the jam nut (counterclockwise) on the lock cylinder cable.
2. Turn the cable adjuster until the desired play in the release pedal is achieved.
3. Retighten the jam nut (clockwise) on the cable.
4. Tilt the wheelchair to any tilt position. Make sure the wheelchair holds the position.
NOTE: If the wheelchair does not hold the position, repeat STEPS 1-4 until the wheelchair is able
to hold the tilted position.
FIGURE 10.2 Adjusting the Cable Assembly
Cable Adjuster
Jam Nut