Filter
Top Products
SECTION 10—TILT
Part No 1134839 69 Power Tiger™
SECTION 10—TILT
Removing/Installing/Adjusting the Cable Assembly
Removing/Installing the Cable Assembly
NOTE: For this procedure, refer to FIGURE 10.1.
1. Remove the seat frame from the base frame. Refer to Removing/Installing the Seat
Frame on page 64.
2. Loosen back locknut and rotate counterclockwise five to six revolutions.
3. Rotate cable adjuster and jam nut counterclockwise all the way out to the end of the
threads.
4. Rotate front locknut counterclockwise completely off of threads and onto the exposed
cable.
5. Pull threaded portion of cable assembly back beyond back tab of the tilt mechanism.
6. Slide the exposed cable out the side of the back tab.
7. Remove anchor end of cable from front tab.
8. To install, perform the following:
A. Reverse STEPS 1-7.
B. Adjust cable. Refer to Removing/Installing the Seat Frame on page 64.
FIGURE 10.1 Removing/Installing the Cable Assembly
Cable Adjuster
Jam Nut
Tilt Mechanism
Anchor End
of Cable
Front Tab
Exposed Cable
Front Locknut
Back Tab
Back Locknut