Filter
Top Products
SECTION 6—WHEELCHAIR OPERATION
Part No 1134839 37 Power Tiger™
NOTE: Note the position of the coved spacers before disassembly.Remove the mounting screw and
coved spacer that secures the lower footrest assembly.
3. Position the footrest assembly to the desired height.
4. Secure footrest assembly with existing mounting screw and coved spacer. Securely
tighten.
NOTE: Make sure spacers are positioned
properly when reassembling so as not to
damage the frame mounting tubes.
5. Reinstall the footrest(s) onto the
wheelchair. Refer to Installing/
Removing Footrests on page 35.
6. Reinstall any accessory onto the
footrest(s).
7. Repeat STEPS 1-7 for other footrest.
FIGURE 6.7 Adjusting Footrest Height -
60° MFX, 70° Taper
Removing/Installing the Calf Strap
NOTE: For this procedure, refer to FIGURE 6.8.
1. Remove the calf strap from the package.
2. Secure the calf strap to the wheelchair using the hook and loop strips (not shown) on
the vertical seat frame tubing just above the footrest locking mechanism and below the
horizontal seat frame tubing.
FIGURE 6.8 Removing/Installing the Calf Strap
Footrest Assembly
Mounting Screw
Heel Loop
Coved Spacer
Footrest Locking Mechanism
Seat
Calf Strap
Front View of
Wheelchair
Vertical Seat Frame
Tubing