Filter
Top Products
SECTION 7—FRONT RIGGINGS
Part No 1134839 59 Power Tiger™
FIGURE 7.8 Installing 3-Inch Extension
Replacing Sector Block
NOTE: For this procedure, refer to FIGURE 7.9.
1. Remove the hex screw and washer that secure the existing sector block to the
wheelchair frame.
2. Position the new sector block on the wheelchair frame. Make sure the locking pin is
facing up.
3. Secure the new sector block to the wheelchair frame with the existing hex screw and
washer. Use Loctite
®
242 and securely tighten.
FIGURE 7.9 Replacing Sector Block
Locknut
(STEP 4)
Washer (STEP 4)
Hex Screw
(STEP 4)
Socket Screw, Coved
Washer and Locknut
(STEPS 2, 6)
Washer
Hex Screw
Wheelchair Frame
Locking Pin
Sector Block