Filter
Top Products
SECTION 7—FRONT RIGGINGS
Power Tiger™ 58 Part No 1134839
FIGURE 7.7 70° MFX and 90° Footrests Only
Installing 3-Inch Extension
NOTE: For this procedure, refer to FIGURE 7.8 on page 59.
NOTE: Note the position of the attaching hardware for proper reassembly of the footrest.
NOTE: If using any type of extension with the adjustable angle footplate, refer to Installing
Flip-Up Footplates on page 54.
1. Remove any accessories that are attached to the footrests.
2. Remove the socket screw, coved washer and locknut that secure the footplate to the
footrest support.
3. Insert the 3-inch extension into the footrest support and align the mounting holes.
4. Secure the 3-inch extension to the footrest support with new hex screw, washer and
locknut. Securely tighten.
5. Position the footplate at the desired height.
ƽ WARNING
DO NOT overtighten. Footrest must be able to rotate upward from the horizontal
to vertical position.
6. Reinstall the socket screw through the mounting holes of the footplate and footrest
support.
7. Secure the footplate to the footrest support with the coved washer and locknut.
Securely tighten.
Locknut
Footplate
Footrest Support
Height Adjustment Holes
Socket Screw and
Coved Washer