Filter
Top Products
SECTION 6—WHEELCHAIR OPERATION
Part No 1134839 39 Power Tiger™
Adjusting T-Arm Height
NOTE: For this procedure, refer to FIGURE 6.10 on page 39.
1. Unlock the T-arm by flipping the T-arm release lever towards the inside of the
wheelchair.
NOTE: If necessary, pull out on the T-arm release lever and rotate 180° so it can be flipped towards
the outside of the wheelchair.
2. Slide the T-arm to one of:
• Low Height T-Arms - Nine positions.
• High Height T-Arms - Seven positions.
NOTE: If the inside T-arm post does not slide up and down in the outside T-arm post as desired,
perform one of the following:
• Tighten - Tightening the set screws on the outside T-arm post will make it harder to move
the inside T-arm post up and down.
• Loosen - Loosening the set screws on the outside T-arm post will make it easier to move the
inside T-arm post up and down.
3. Lock the T-arm by flipping the T-arm release lever towards the front of the wheelchair.
FIGURE 6.10 Adjusting T-Arm Height
Installing/Removing Stroller Handles
NOTE: For this procedure, refer to FIGURE 6.11.
Installing
1. Remove the back cane grips and plug buttons from both back canes.
2. Slide the stroller handle into the back canes.
3. Align the mounting holes of the stroller handle and the back canes.
4. Insert the two quick-release pins through the mounting holes of the stroller handle
and the back cane.
T-Arm Release Lever -
Unlocked Position
Set Screws
Outside T-Arm Post
T-Arm Release Lever - Locked Position
Inside T-Arm
Post