Filter
Top Products
SECTION 6—WHEELCHAIR OPERATION
Power Tiger™ 34 Part No 1134839
Engaging the Tilt-in-Space
ƽ WARNING
ALWAYS make sure that the wheelchair is stable before using the tilt-in-space.
NEVER operate the wheelchair while in any tilt position over 20° relative to the
vertical position. If the limit switch does not stop the wheelchair from operating in a
tilt position greater than 20° relative to the vertical position, have the limit switch
adjusted by a qualified technician.
Make sure the occupant of the wheelchair is properly positioned and always use the
seat positioning strap.
ALWAYS engage both wheel locks.
DO NOT use the release pedal of the tilt mechanism to gain leverage in tipping the
wheelchair. The release pedal was not designed to be used in this manner and may
cause injury to the assistant and/or user or damage to the wheelchair.
NOTE: For this procedure, refer to FIGURE 6.4 on page 35.
1. Place the wheelchair on a level surface.
2. Engage both wheel locks. Refer to Engaging/Disengaging the Wheel Locks
on page 40.
3. Move the locking mechanism on the release pedal to the unlocked position. See Detail
"A".
4. Inform the occupant of the wheelchair that the wheelchair is about to be tilted and
remind them to lean back.
5. Make sure the occupant's hands and body are clear of all pinch points.
6. Stand behind the wheelchair and apply pressure to the release pedal.
7. Slowly pull back on the back canes while stepping on the release pedal.
8. To lower the seat, reverse STEPS 1-7.
9. When the seat reaches the desired angle, slowly relieve the pressure on the
release pedal.
10. Move the locking mechanism on the release pedal to the locked position. See
Detail "A".
11. Disengage wheel locks before attempting to move occupant. Refer to Engaging/
Disengaging the Wheel Locks on page 40.