Filter
Top Products
12 ANTI-TIPPER
Part No 1167484 85 Invacare
®
Crossfire™T7A Wheelchair
Adjusting Anti-tipper
1. Press in the lock button that secures the anti-tipper wheel assembly to the anti-tipper bar.
2. Adjust the height of the anti-tipper wheels to between 1-1/2 and 2-inches of the ground/floor.
3. Repeat STEPS 1-2 for the opposite anti-tipper.
Replacing Anti-tipper
1. Press in the release button that secures the existing anti-tipper to the anti-tipper bracket and remove the anti-tipper from the anti-tipper bracket.
2. Insert the new anti-tipper into the anti-tipper bracket until lock buttons protrude out of mounting hole.
3. Press in the lock button on the anti-tipper bar and install the anti-tipper wheels onto the new anti-tipper bar.
4. Repeat STEPS 1-3 for the opposite anti-tipper.
5. Measure the distance between the bottom of the anti-tipper wheels and the ground floor.
6. If necessary, adjust the height of the anti-tippers. Refer to Adjusting Anti-tipper
on page 85.
ƽ
WARNING
When anti-tippers are used, anti-tippers MUST be adjusted to maintain a 1-1/2 to 2-inch clearance between the bottom of
the anti-tipper wheels and the ground/ floor. This spacing should ALWAYS be checked whenever adjustments/changes are
made to the wheelchair. Failure to maintain proper spacing may result in the chair tipping over backward causing serious
injury or property damage.
ƽ
WARNING
When anti-tippers are used, anti-tippers MUST be adjusted to maintain a 1-1/2 to 2-inch clearance between the bottom of
the anti-tipper wheels and the ground/floor. This spacing should ALWAYS be checked whenever adjustments/changes are
made to the wheelchair. Failure to maintain proper spacing may result in the chair tipping over backward causing serious
injury or property damage
.