Filter
Top Products
11 WHEELS
Part No 1167484 65 Invacare
®
Crossfire™T7A Wheelchair
6. Flip the handle of the quad-release axle down to release the detent pin ensuring that the locking pins are fully released.
7. Repeat the above procedures until the quad-release axle locks correctly.
FIGURE4 Adjusting Quad-Release Handles
Removing Play from Rear Wheels
1. With the rear wheel and quad-release axle still mounted onto the wheelchair, make the following adjustment:
• Tighten the length adjusting screw until there is no in and out movement of the quad-release axle and rear wheel.
11.5 Handrim Replacement
1. Remove the rear wheel from the wheelchair. Refer to Removing/Installing Rear Wheels on page 62.
2. Remove all air from the tube by pressing down on the pin in the center of the valve stem.
3. While carefully holding the tire, tube and rim strip to one side, hold the allen screws and remove the locknuts that secure the handrim to the
rear wheel.
ƽ
WARNING
Tire MUST be fully deflated before any disassembly procedures are performed. Otherwise injury or damage may result.
Adjusting Locknut
(On Quick-Release Axle)
Length
Adjustment
Screw
Removing Play from Rear Wheels
Adjusting Quad-Release Handle In and/or Out
Locking Pins
Camber Bar
Locking
Screw
Quad Release
Handle