Filter
Top Products
11 WHEELS
Invacare
®
Crossfire™T7A Wheelchair 70 Part No 1167484
Repositioning the Camber Tube Clamp Socket Screws
1. Remove the rear wheels. Refer to Removing/Installing Rear Wheels on page 62.
2. Refer to Socket Screw Mounting Positions
in to determine which socket screw(s) MUST be moved and to which mounting positions.
3. Remove the four socket screws and washers from both camber tube clamps.
4. Align the desired mounting positions of the camber tube clamps with the opening of the camber tube supports.
5. Install the four socket screws and washers into the desired
mounting positions of both camber tube clamps. Hand tighten.
6. Slide the camber tube forward or backward to adjust the wheelbase
length to the desired position. Securely tighten the four socket
screws.
7. Install the rear wheels. Refer to Removing/Installing Rear Wheels
on page 62.
FIGURE9 Repositioning the Camber Tube Clamp Socket Screws
Reversing the Camber Tube Clamp Direction
1. Remove the rear wheels. Refer to Removing/Installing Rear Wheels on page 62.
2. Remove the four socket screws and washers that secure the two camber tube clamps to the camber tube supports.
3. Rotate the camber tube so that the camber tube clamps face the opposite direction.
ƽ
CAUTION
Ensure one empty mounting position remains
between the two socket screws, otherwise
damage to the wheelchair may occur.
Ensure that both camber tube clamps are adjust to
the same position in the camber tube support. This
will ensure that the camber tube remains at 90° to
each side frame.
Socket Screws
Washers
Camber
Tube
Support
Camber Tube
Camber Tube Clamp