Filter
Top Products
11 WHEELS
Part No 1167484 63 Invacare
®
Crossfire™T7A Wheelchair
FIGURE1 Removing/Installing Rear Wheels
11.2 Adjusting Quick-Release Axles
1. Remove rear wheel and quick-release axle from the wheelchair.
Refer to Removing/Installing Rear Wheels
on page 62.
2. Depress detent pin in the quick-release axle and slide axle through
the wheel hub.
3. Release detent pin ensuring that the locking pins are fully released.
4. Increase or decrease end play by adjusting the locknut on the end
of the quick-release axle.
5. Reinstall rear wheel onto the wheelchair. Refer to
Removing/Installing Rear Wheels
on page 62.
FIGURE2 Adjusting Quick-Release Axles
Wheelchair Frame
Rear
Wheel
Locking Pins
Quick-Release
Axle
Detent Pin
Quad-Release Axle not
shown. Locking pins on the
Quad-Release Axle are the
same as Quick-Release
Axle.
Locking
Pins
Quick-Release
Axle
Detent
Pin
Locknut
Adjustable Axle Position
Camber Bar
Wheel
Hub
End of Quick Release axle is shown for reference
only. It is not visible when inserted into camber bar.