Filter
Top Products
10 WHEEL LOCKS
Part No 1167484 61 Invacare
®
Crossfire™T7A Wheelchair
10.3 Converting Wheel Lock From Push-to-Lock to Pull-to-Lock or Pull-to-Lock to Push-to-Lock
Converting From Push-to-Lock to Pull-to-Lock
1. Remove set screw from the lower stop position (Detail “A”).
2. Push wheel lock handle down to access the upper stop position (Detail “B”).
3. Install set screw into upper stop position.
4. Pull wheel lock handle up to engage wheel lock. If wheel lock does not properly engage the wheel, refer to Adjusting the Wheel Lock
on page 59.
Converting From Pull-to-Lock to Push-to-Lock
1. Remove set screw from the upper stop position (Detail “B”).
2. Pull wheel lock handle up to access the lower stop position (Detail “A”).
3. Install set screw into lower stop position.
4. Push wheel lock handle down to engage wheel lock. If wheel lock does not properly engage the wheel, refer to Adjusting the Wheel Lock
on
page 59.
FIGURE3 Converting Wheel Lock From Push-to-Lock to Pull-to-Lock or Pull-to-Lock to Push-to-Lock
As the wheel lock handle is pushed downwards, the wheel lock will engage and then disengage the wheel.
As the wheel lock handle is pulled upwards, the wheel lock will engage and then disengage the wheel.
DETAIL “A”
WHEEL LOCK IN
PUSH-TO-LOCK
CONFIGURATION
Set Screw
(in Lower Stop Position)
Wheel Lock
Handle
DETAIL “B”
WHEEL LOCK IN
PULL-TO-LOCK
CONFIGURATION
Set Screw (in Upper Stop Position)
Wheel Lock
Handle