Filter
Top Products
9 SEAT
Invacare
®
Crossfire™T7A Wheelchair 58 Part No 1167484
• Moving bottom mounting screws to a new adjustment hole in the crescent link.
• Moving both mounting screws to a new adjustment hole in the crescent link.
7. Once seat angle has been adjusted, install one washer and one locknut onto each mounting screw in the crescent links.
8. Securely tighten all four mounting screws and locknuts.
9. Securely tighten both mounting screws and locknuts that secure the front of the seat frame to the side frame.
10. Position wheelchair right side up.
11. Unfold back. Refer to Unfolding/Folding the Back
on page 41.
12. Check for stability. Refer to on page 9.
FIGURE2 Seat Angle Adjustment
Mounting screws in both crescent links MUST be adjusted to the same adjustment hole.
Mounting
Screw
Mounting
Screw
Side Frame
Crescent
Link
Adjustment
Holes
Side
Frame
See Detail “A”
Mounting
Screw
Mounting Screw
DETAIL “A”
Seat Frame
Locknuts and
Washers