Filter
Top Products
11 WHEELS
Part No 1167484 69 Invacare
®
Crossfire™T7A Wheelchair
Repositioning the Camber Tube Clamps
1. Remove the rear wheels. Refer to Removing/Installing Rear Wheels on page 62.
2. Loosen, but DO NOT remove, the four socket screws and washers that secure the two camber tube clamps to the camber tube supports.
3. Slide the camber tube forward or backward to adjust the wheelbase length to the desired position.
4. Securely tighten the four socket screws and washers that secure the two camber tube clamps to the camber tube supports.
5. Install the rear wheels. Refer to Removing/Installing Rear Wheels
on page 62.
FIGURE8 Repositioning the Camber Tube Clamps
Ensure that both camber tube clamps are adjust to the same position in the camber tube support. This will ensure that the camber
tube remains at 90° to each side frame.
Camber
Tube
Socket Screws and
Washers
Camber Tube Support
Camber
Tube Clamp