Filter
Top Products
11 WHEELS
Part No 1167484 71 Invacare
®
Crossfire™T7A Wheelchair
4. Align the desired mounting positions of the camber tube clamps with the opening of the camber tube supports.
5. Install the four socket screws and washers into the desired mounting positions of both camber tube clamps. Hand tighten.
6. Slide the camber tube forward or backward to adjust the wheelbase length to the desired position. Securely tighten the four socket screws.
7. Install the rear wheels. Refer to Removing/Installing Rear Wheels on page 62.
FIGURE10 Reversing the Camber Tube Clamp Direction
ƽ
CAUTION
Ensure one empty mounting position remains between the two socket screws, otherwise damage to the wheelchair may
occur.
Ensure that both camber tube clamps are adjust to the same position in the camber tube support. This will ensure that the camber
tube remains at 90° to each side frame.
Washers
Camber Tube
Support
Camber Tube
Clamps
Facing Front of Wheelchair
Facing Rear of Wheelchair
Camber Tube Direction
Camber Tube
Camber Tube Clamp
Camber Tube
Camber Tube
Socket Screws