Filter
Top Products
11 WHEELS
Part No 1167484 75 Invacare
®
Crossfire™T7A Wheelchair
11.10 Adjusting the Camber Tube
1. Loosen, but DO NOT remove, the socket head clamp screws in the
camber tube clamps (Detail “A”).
2. Using an "L" square, rotate the axle tube until the flat edge of the
camber tube is at a 90° angle with the ground/floor.
3. Securely tighten the socket screw in the camber tube clamps (Detail
“A”).
4. Determine the toe in/toe out of the wheelchair. Refer to
Determining/Setting Toe In/Toe Out
on page 76.
FIGURE13 Adjusting the Camber Tube
ƽ
WARNING
Camber tube clamps - Make sure the clamp
screws are securely tightened before using the
wheelchair, otherwise injury or damage to the
wheelchair may occur.
Stand behind the wheelchair to determine left or
right.
Ensure camber tube is centered between clamps.
This adjustment is made with the rear wheels
attached to the chair and all four wheels contacting
the floor.
If camber tube is not 0° degrees, then it MUST be
rotated so that the axle bushings are angled up at
their ends (FIGURE13).
Ground/
Floor
Flat Edge of
Camber Tube
“L” Square
Socket Head Clamp Screw
Camber Tube
Clamp
DETAIL “A” - SIDE VIEW
Ensure flat edge of camber
tube is parallel with vertical
edge of “L” square