Filter
Top Products
10 WHEEL LOCKS
Part No 1167484 59 Invacare
®
Crossfire™T7A Wheelchair
10 Wheel Locks
10.1 Replacing/Adjusting the Wheel Locks
Replacing the Wheel Lock
1. Loosen the two mounting screws and remove the existing wheel lock from the wheelchair.
2. Using the two mounting screws, install the new wheel lock. Securely tighten.
Adjusting the Wheel Lock
1. Engage the wheel locks.
2. If necessary, loosen the two mounting screws that secure the wheel locks to the wheelchair frame and adjust position of the wheel lock until the
3/16-inch (1/8-inch for urethane wheels) measurement is obtained for correct wheel lock adjustment.
3. Securely tighten the two mounting screw(s).
4. Engage the wheel locks and push against the wheelchair and determine if the wheel locks engage the tires enough to hold the wheelchair.
ƽ
WARNING
After any adjustments, repair or service and before use, make sure all attaching hardware is tightened securely - otherwise
injury or damage may occur.
ƽ
WARNING
If wheel locks DO NOT hold the occupied wheelchair in place contact a qualified technician - otherwise injury or damage
may occur.
Before adjusting or replacing wheel locks, ensure that the tires are inflated to the recommended psi on the sidewall of the tire.
Any wheel lock adjustment should embed the wheel lock shoe at least 3/16-inch into the pneumatic tire (1/8-inch for urethane
wheels) when engaged.