Filter
Top Products
SECTION 7—BACK ADJUSTMENTS
Part No 1114842 93 2G Tarsys®Powered Seating System
Removing/Installing Arm Pivots
NOTE: For this procedure, refer to FIGURE 7.10.
NOTE: The following procedure is for Tilt/Recline and Recline-Only seating systems.
Removing
1. If necessary, remove the lateral supports from the seating system. Refer to
Installing/Removing/Adjusting Lateral Supports
on page 95.
2. Note the position of the existing arm pivot.
3. Loosen, but DO NOT remove, the two hex bolts that secure the existing arm pivot to
the back slide.
4. Slide the existing arm pivot off the back slide.
Installing
1. If necessary, loosely install the four T-nuts and hex bolts onto the new arm pivot.
2. Position the new/existing arm pivot and line up the T-nuts with the slots in the
new/existing back slides.
3. Slide the new/existing arm pivot to the position noted in STEP 2 above.
NOTE: If a change in armrest height is desired, Refer to Adjusting Armrest Height on page 115.
4. Torque the two hex bolts that secure the new/existing arm pivot to the back slide to 50
in-lbs ± 20%.
5. If necessary, repeat STEPS 1-4 for the opposite side of the seating system.
6. If necessary, install the lateral supports onto the seating system. Refer to
Installing/Removing/Adjusting Lateral Supports on page 95.
FIGURE 7.10 Removing/Installing Arm Pivots
Hex Bolts
T-Nuts
Channel
Back Slid
e
Arm Pivot
Back Cane