Filter
Top Products
SECTION 6—SEAT ADJUSTMENTS
Part No 1114842 55 2G Tarsys®Powered Seating System
2. Reinstall the five hex bolts, locknuts, coved washer and spacers that secure the seat
pan to the seat frame. Torque to 75 in-lbs ± 20%.
3. Remove the protective strips from the new seat pan and reinstall the seat cushion onto
the seat pan.
FIGURE 6.2 Removing/Installing Seat Pan
Adjusting Seat Width
Preparing to Adjust Seat Width
NOTE: Reverse these steps after adjusting seat width and before returning the wheelchair to the user.
1. Tilt backward 5 to 10 degrees and/or recline backward 5 to 10 degrees in order to
enable hardware removal.
2. Remove the telescoping front rigging supports. Refer to Adjusting/Replacing
Telescoping Front Rigging Supports on page 73.
3. Remove the joystick(s). Refer to Removing/Installing Joystick(s)
on page 149.
4. Remove the arms. Refer to Arms
on page 114.
5. Remove the existing spreader bar. Refer to Removing/Installing Spreader Bar on page 87.
6. Remove the existing back pan. Refer to Removing/Installing Back Pan
on page 85.
7. Remove the side shrouds. Refer to Removing/Installing Side Shrouds on page 100.
8. Remove the existing seat pan. Refer to Removing/Installing Seat Pan on page 54.
Hex
Bolts
Seat Pan
Coved
Washer
Seat Frame
Spacers
Locknut
Locknut