Filter
Top Products
SECTION 10—ARMS
2G Tarsys®Powered Seating System 116 Part No 1114842
FIGURE 10.2 Adjusting Armrest Height
Installing/Removing Flip-Back Armrests
ƽ WARNING
Make sure the flip-back armrest release and height adjustment levers are in the
locked position before using the wheelchair.
NOTE: For this procedure, refer to FIGURE 10.3 on page 117.
NOTE: Flip-back armrest release lever MUST be in the unlocked (up-horizontal) position when
placing the armrest into the arm sockets.
Installing
1. Visually inspect to ensure flip back armrest release lever is in the unlocked
(up-horizontal) position (Detail “C”).
2. Slide the flip-back armrest into the arm sockets on the seat frame.
3. Install the quick-release pin through the rear arm socket and flip-back armrest.
4. Lock the flip-back armrest by pressing the flip-back armrest release lever into the
down (vertical) position (Detail “C”).
5. Connect joystick cable to joystick connector. Refer to FIGURE 10.3, Detail “A.”
6. Attach the cable to the back cane with a tie-wrap (not shown).
7. Repeat STEPS 1-6 for the opposite flip-back armrest.
Armrest
Socket Bolt
Height Adjustment Holes
Locknut
Back Cane
Socket
Screws/T-Nuts