Filter
Top Products
SECTION 15—WIRING AND CABLES
Part No 1114842 163 2G Tarsys®Powered Seating System
Joystick, SAC or TRSS Cables
NOTE: For this procedure, refer to FIGURE 15.8.
1. Tie-wrap the joystick cable from the MK
5
controller to the rear pivot assembly. Refer
to FIGURE 15.8.
FIGURE 15.8 Joystick, SAC or TRSS Cables
2. Connect the joystick cables.
3. Bundle up the connected cables until there is no slack and then tie-wrap them and the
SAC or TRSS cables (if present) to the armrest.
All Cables (Final Steps)
NOTE: For this procedure, refer to FIGURE 15.9 on page 164.
1. Connect the auxiliary power connectors and any remaining cables.
2. Bundle up all loose cables and then tie-wrap them to the rear pivot assembly and to
the rear of the tilt actuator. Refer to FIGURE 15.9.
3. Install the rear shroud in the location indicated in FIGURE 15.8. Refer to
Removing/Installing Rear Shroud
on page 102.
CAUTION
The wheelchair must be carefully tilted backward and forward to the maximum
positions in order to determine if any cables are snagged and stretched by the bat-
tery controller shroud. Tie-wrap any loose cables and test again until there is no
snagging.
Rear Pivot assembly
Joystick Cable
Battery Controller
Shroud
Tie-Wraps