Filter
Top Products
SECTION 5—INTERFACE HARDWARE
Part No 1114842 45 2G Tarsys®Powered Seating System
Removing/Installing the Front Pivot Assembly
NOTE: For this procedure, refer to FIGURE 5.4 on page 46.
Removing
1. Remove the seat assembly. Refer to Removing/Installing the Seat on page 75.
2. Tilt Only and Tilt/Recline Systems - Remove the shoulder bolt and locknut securing
the front of the tilt actuator to the front pivot assembly.
3. Note the mounting location of the four hex screws and locknuts securing the front
pivot assembly to the seat brackets.
4. Remove the four hex screws and locknut securing the front pivot assembly to the seat
brackets.
5. Remove the front pivot assembly from the seat brackets.
Installing
1. Align the front pivot assembly with the seat brackets.
2. Secure the front pivot assembly to the seat brackets in the location noted in STEP 3 of
Removing on page 45. Torque to 13 ft-lbs ± 20%.
3. Tilt Only and Tilt/Recline Systems - Secure the front of the tilt actuator to the front
pivot assembly using the shoulder bolt and the locknut. Torque to 23 ft-lbs ± 20%.
4. Install the seat assembly. Refer to Removing/Installing the Seat on page 75.