Filter
Top Products
SECTION 13—TILT AND RECLINE
Part No 1114842 129 2G Tarsys®Powered Seating System
Optional Four-Way Toggle Switch
NOTE: For this procedure, refer to FIGURE 13.3.
1. Make sure the wheelchair is on a level surface.
2. Refer to the charts which follow for the operation of the seating system using a
four-way toggle switch:
NOTE: The charts which follow show the factory programmed settings only. Switch assignments
can be reprogrammed.
NOTE: If the wheelchair is equipped with switch options, scan to the correct ECU or Auxiliary
Mode and activate the control device in the corresponding “forward” direction to operate the tilt
function. Refer to MK
5
EX and MK
5
TT-EX Electronics Service Manual, part number 1114808,
for complete switch option operating instructions.
3. Release four-way toggle switch to neutral position.
FIGURE 13.3 Optional Four-Way Toggle Switch
SEATING SYSTEM FOUR-WAY TOGGLE SWITCH
FORWARD REAR LEFT RIGHT
Tilt Only Increase/Decrease
the Tilt Angle* N/A N/A
Power Legrest
Up/Down*
Recline Only
N/A
Increase/Decrease
the Recline Angle*
Increase/Decrease
the Back Height
(VSR)*
Power Legrest
Up/Down*
Tilt/Recline
Increase/Decrease
the Tilt Angle*
Increase/Decrease
the Recline Angle
Increase/Decrease
the Back Height
(VSR)*
Power Legrest
Up/Down*
*NOTE: The four-way toggle switch will alternate functions (increase tilt angle, decrease tilt
angle) after it has been released to the neutral position for a minimum of three seconds. Refer to
MK
5
™ EX™ and MK
5
TT-EX ELECTRONICS Service Manual, part number 1114808 for
complete four-way toggle switch operating instructions.
LED
Left
Forward
Rear
Four-Way Toggle Switch
Right