Filter
Top Products
SECTION 7—BACK ADJUSTMENTS
2G Tarsys®Powered Seating System 86 Part No 1114842
ii. Reinstall the two mounting screws and locknuts that secure the VSR actuator
mounting bracket to the new back pan. Tighten securely.
iii. Connect the VSR actuator to the TRCM or TAC.
iv. Adjust back height. Refer to Adjusting the Back Height on page 92.
6. Install the cushion onto the new back pan.
7. Install the headrest onto the seating system. Refer to Removing/Installing/Adjusting
Headrest on page 124.
FIGURE 7.4 Removing/Installing Back Pan
Headrest Mounting Bracket
Button
Screws
Hex
Screws
VSR Actuator
Mounting Bracket
VSR Actuator
Back Pan
Back Slide
Mounting Screws
ABS Back
Back Pan
Back Slide
Mounting Screws
Rear View
Profile Back
Spacer
NOTE: For back
widths of 17, 19, or 21
inches, spacers are
required between back
slide and back pan.