Invacare 2GTR Wheelchair User Manual


 
SECTION 10—ARMS
Part No 1114842 115 2G Tarsys®Powered Seating System
FIGURE 10.1 Removing/Installing Reclining Armrests
Adjusting Armrest Height
NOTE: For this procedure, refer to FIGURE 10.2 on page 116.
1. Make sure the seating system is in the full upright position.
2. Remove the socket bolt and locknut that secure the front of the upper armrest to the
lower armrest.
3. Loosen, but DO NOT remove, the two socket screws and T-nuts that secure the rear of
the recliner armrest to the back cane.
4. Refer to the chart below and adjust the armrest to the desired height for the user.
*NOTE: Front armrest mounting holes are numbered from bottom to top for reference only. There
are no numbers on the armrests.
5. Reinstall the socket bolt through the mounting hole determined in STEP 4.
6. Reinstall the locknut and tighten securely.
7. While holding the armrest level, tighten the two socket screws and T-nuts securely.
8. Repeat STEPS 2-7 for the opposite side if necessary.
*HOLE NUMBER 123456
ARMREST HEIGHT (IN INCHES) 111213141516
Armrest
Release Lever
Release Button
Locked
(DOWN -
VERTICAL)
Unlocked
(UP -
HORIZONTAL)