Filter
Top Products
Part No. 1106628 55 Solara jr.
USING THE OPTIONAL QUICK RELEASE PIN (FIGURE 2)
NOTE: The Quick Release Pin replaces the mount-
ing screw that is used to lock the angle adjustment
of the contracture support.
NOTE: If not installed at time of shipment, the quick
release pin must be installed by a qualified techni-
cian only, using a 1/8-inch pop rivet.
1. Press the button on the quick release pin
and insert through the contracture support
and the angle adjustment bracket.
2. If necessary adjust the angle of the con-
tracture assembly. Refer to
CONTRAC-
TURE ASSEMBLY ANGLE ADJUSTMENT in this procedure of the manual.
3. Repeat STEPS 1-2 on the remaining contracture assembly.
ANGLE ADJUSTMENT OF THE CONTRACTURE
FOOTPLATE (FIGURE 3)
1. Loosen, but DO NOT, remove the two
(2) flat screws, washers and locknuts that
secure contracture footplate to the
footplate hinge.
2. Tilt the contracture footplate UP/DOWN
to achieve desired angle.
3. Retighten the two (2) flat screws, washers
and locknuts that secures the contracture
foot plate to the footplate hinge.
4. If necessary repeat STEPS 1-3 on remain-
ing contracture footplate.
CONTRACTURE FOOTPLATE DEPTH ADJUSTMENT
(FIGURE 4)
NOTE: Refer to the WARNINGS in PROCEDURE 1 of this manual.
NOTE: Observe the angle of the contracture footplate for reinstallation.
1. Remove the two (2) flat screws, washers and locknuts that secure the contracture footplate
to the footplate hinge.
2. Move the contracture footplate to one (1) of four (4) mounting holes.
3. Reinstall the two (2) flat screws, washers and locknuts that secures the contracture foot
plate to the footplate hinge.
FIGURE 2 - USING THE OPTIONAL
QUICK RELEASE PIN
Quick Release Pin
Angle
Adjustment
Bracket
Contracture
Support
Button
Pop Rivet
FIGURE 3 - ANGLE ADJUSTMENT
OF THE
CONTRACTURE FOOTPLATE
Contracture
Footplate
Flat Screws
NOTE: Mounting hardware
shown removed for clarity only.
Washers
Footplate
Hinge
Lock Nuts
Contracture
Assembly
PROCEDURE 10CONTRACTURE FOOTPLATE
CONTRACTURE FOOTPLATE