Filter
Top Products
Part No. 1106628 21 Solara jr.
ADJUSTING SWINGAWAY FOOTREST HEIGHT
HEIGHT ADJUSTMENT RANGES:
60° 13-17-inches
70° 13-17-inches
90° 5-8-inches
90° 5-11-inches (with 3-inch extension)
NOTE: If using ANY type of extension with the AD-
JUSTABLE FLIP-UP FOOTPLATE, refer to
ADJUST-
ING ADJUSTABLE ANGLE FLIP-UP FOOTPLATES -
PERPENDICULAR AND/OR INVERSION/EVERSION
ADJUSTMENT in this procedure of the manual.
60°, 70° and 70° TAPER (FIGURE 2)
1. Remove the footrest from the wheelchair.
Refer to INSTALLING/REMOVING
SWINGAWAY FOOTREST in this proce-
dure of the manual.
2. Remove the hex screw and coved spacer and slide the footrest up or down on its mounting
tube until the desired footrest height is achieved.
3. Reassemble the hex screw and coved spacer through the footrest upper support and
mounting tube as shown in FIGURE 2.
4. Securely tighten the hex screw and coved spacer.
5. Install the footrest assembly onto the wheelchair. Refer to
INSTALLING/REMOVING
SWINGAWAY FOOTREST in this procedure of the manual.
6. Repeat STEPS 1-5 for the opposite side of the wheelchair, if necessary.
90°
AND 70°
MFX
(FIGURE 3)
1. Remove the footrest from the wheelchair.
Refer to INSTALLING/REMOVING
SWINGAWAY FOOTREST in this
procedure of the manual.
2. Remove the socket screw, washers, coved
spacer and locknut that secures the
footplate hinge to the footrest support.
3. Slide the footrest support to the desired
position.
4. Secure the footrest support to the
footplate hinge. Refer to FIGURE 3 for
correct hardware orientation.
5. Securely tighten the socket screw, wash-
ers, coved spacer and locknut.
6. Install the footrest assembly onto the
wheelchair. Refer to
INSTALLING/
REMOVING SWINGAWAY FOOTREST
in this procedure of the manual.
7. Repeat STEPS 1-6 for the opposite side of the wheelchair, if necessary.
Hex Screw
Coved
Spacer
FIGURE 2 - ADJUSTING
SWINGAWAY FOOTREST
HEIGHT - 60° , 70° AND 70°
TAPER
Footrest Upper
Support
Mounting
Tube
Footplate
FIGURE 3 - ADJUSTING SWINGAWAY
FOOTREST HEIGHT - 90° AND 70° MFX
Footplate Hinge
Footrest Support
Washers
Coved Spacer
Locknut
Socket Screw
Locknut
3-inch
Extension
Hex Screw
Height Adjustment
Holes
FRONT RIGGINGS PROCEDURE 4
FRONT RIGGINGS